Directions of Use for raound Arch
1. Mount elastic band with screw (s). Pull pin
(a) to rotate arm away from transport position to hole indicating desired
diameter (b). Lift safety lever (c), lift clamp lever (d) and remove U-clamp
(e).
2. Hold handle (a) with left hand, press
trigger (b) with right and slide assembly until red pointer (d) points to
desired diameter on vertical scale.
3. Bring flexible band towards clamp (a),
replace U-clamp (b), align the desired diameter on inner scale of band to the
top of the clamp (c) and lower clamp lever (d).
Disassembling the Mold!
Lay masonry on form alternating between left
and right sides until arch is completed. To remove form once mortar has set,
hold handle (e) and either shorten centre pole by removing clip (f) or lower
form by pressing trigger (b) of Figure
2. Move form away from arch and disassemble in reverse order to instructions.
When unclamping elastic band, lift clamp lever (d) in a controlled and slow
manner to prevent pinching hand against elastic band.
Warning: Read
safety direction before use. Failure to read all labels and follow all
instructions may result in inadequate forms and/or serious injury.
